The pipes to be protected must be freely accessible and undamaged. Lay the heating cable straight along the pipe without crossing or overlapping and fasten it at regular intervals with temperature‑resistant tape or cable ties so that it lies flush against the pipe. The thermostat must also be attached firmly to the pipe.

Once the cable is attached to the pipe, plug the protective contact plug into a 230 V socket. The integrated thermostat switches on at a temperature of +3 °C and switches off again at +13 °C.

If a plastic pipe is to be protected against frost, the heating cable must not be installed directly on the pipe. First wrap the pipe completely with aluminium adhesive tape. This increases heat transfer and ensures the heat is distributed evenly over the pipe.

The cable must not be operated when coiled or wound. Avoid kinks and any mechanical damage. Follow all safety instructions in the manual. Installed heating cables must be protected against animal bite.

The heating cable has an IP67 protection rating. This means it is dust‑tight and protected against temporary immersion. However, it must not lie in water for extended periods or be in permanent contact with water.

Some plant species, e.g. palms, can be protected from frost with our cables if they are installed correctly. Important: the heating cable must never come into direct contact with the plant. Always use suitable insulation and observe the maximum surface temperature. If the cable overheats and burns out, the plants may also be damaged.